Vermicompost-Hand measureing device-

Keerthivasan-cdm·vermicompost-Hand-measureing-device-

This repository ships a schematic but no board layout.

About the Vermicompost-Hand measureing device- PCB

Vermicompost-Hand measureing device- is an open source ESP32 PCB design by Keerthivasan-cdm, published on GitHub. It is a board, with 11 components from 10 distinct parts.

Its main chip is the ESP32_XIAO_C3_THT, from the ESP32 family. Other key parts include the TP4056-Module_smd+tht. By type, the board carries 8 connectors, 2 ICs and 1 resistor.

It belongs with the power & battery and sensors designs in this gallery.

From the project

A battery-powered handheld instrument that checks vermicompost quality in the field. It shows moisture and temperature on a 320 × 240 color TFT, with good / normal / bad status colors. The KiCad schematic for the device is included.

Main components on the Vermicompost-Hand measureing device-

ESP32_XIAO_C3_THTTP4056-Module_smd+tht

Vermicompost-Hand measureing device- bill of materials (BOM)

11 components, 10 distinct parts.

QtyPartRefs
1
ESP32_XIAO_C3_THT
U1
1
TP4056-Module_smd+tht
U2
1
temp
J1
1
moister
J2
2
DISPLAY
J3, J8
1
RELAY
J4
1
DISPLAY
J5
1
switch 1
J6
1
OUT
J7
1
4.7K
R1

Vermicompost-Hand measureing device- design files

The KiCad project lives in the Keerthivasan-cdm/vermicompost-Hand-measureing-device- repository on GitHub; these links point at the commit this page was built from.

Vermicompost-Hand measureing device-: common questions

What microcontroller does the Vermicompost-Hand measureing device- use?

The Vermicompost-Hand measureing device- is built around the ESP32_XIAO_C3_THT, from the ESP32 family.

How many components are on the Vermicompost-Hand measureing device-?

11 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Vermicompost-Hand measureing device- design files?

From the Keerthivasan-cdm/vermicompost-Hand-measureing-device- repository on GitHub, which has a netlist; the links under Design files point to each one.

Can I use the Vermicompost-Hand measureing device- design in my own project?

The repository has no license, so all rights stay with Keerthivasan-cdm. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Vermicompost-Hand measureing device- without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards