Esphome devices
kjiwa·esphome-devices·hardware/heatpump-bridge/heatpump-bridge.kicad_pcb
About the Esphome devices PCB
Esphome devices is an open source ESP32 PCB design by kjiwa, published on GitHub under the MIT license. It is a 2-layer board measuring 35.6 × 17.8 mm, with 3 components from 3 distinct parts.
Its main chip is the ESP32, from the ESP32 family.
It belongs with the iot & wireless designs in this gallery.
From the project
ESPHome device configurations and KiCad boards for Home Assistant.
The hardware for the heat pump bridge: a small carrier board and a printable enclosure. The carrier board joins a Mitsubishi heat pump's CN105 port to an ESP32 board. It holds a 5 V to 3.3 V logic-level converter and two five-pin headers. The enclosure is a box and lid that hold the carrier board and the ESP32. The heat pump guide explains how to build, print and use them.

Esphome devices bill of materials (BOM)
3 components, 3 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Mitsubishi CN105 | PinHeader_1x05_P2.54mm_Vertical | J_CN105_1 |
| 1 | ESP32 | PinHeader_1x05_P2.54mm_Vertical | J_ESP32_1 |
| 1 | BOB-12009 | BOB-12009 | U_3V3_5V_1 |
Esphome devices design files
The KiCad project lives in the kjiwa/esphome-devices repository on GitHub; these links point at the commit this page was built from.
Esphome devices: common questions
What microcontroller does the Esphome devices use?
The Esphome devices is built around the ESP32, from the ESP32 family.
How big is the Esphome devices PCB?
The Esphome devices measures 35.6 × 17.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Esphome devices?
3 components, from 3 distinct parts. The full bill of materials is listed on this page.
Where can I download the Esphome devices design files?
From the kjiwa/esphome-devices repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Esphome devices design in my own project?
Yes, under the terms of its MIT license, which kjiwa chose for the repository.
Can I test firmware for the Esphome devices without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k