Anden dcc

laullon·anden-dcc·hardware/kicad/anden-dcc.kicad_sch

This repository ships a schematic but no board layout.

About the Anden dcc PCB

Anden dcc is an open source RP2040/RP2350 PCB design by laullon, published on GitHub under the MIT license. It is a board, with 21 components from 18 distinct parts.

Its main chip is the Raspberry Pi Pico W, from the RP2040/RP2350 family. Other key parts include the SN74AHCT125N. By type, the board carries 6 capacitors, 5 resistors, 4 modules, 2 connectors, 1 IC and 1 fuse.

It belongs with the iot & wireless designs in this gallery.

From the project

A Pico W DCC controller for railway dioramas, with Wi-Fi, OTA and a bilingual web UI.

This KiCad project covers the unmodified shield + AHCT buffer option. The hardware comparison also preserves the modified-shield guide as Option B.

Open anden-dcc.kicadpro, then the schematic, in KiCad 8 or later. It is one A3 sheet**, with the four modules, one complete 14-pin level shifter and the small set of passives. Module pins are their connector labels; wire the delivered PD/buck/shield by those labels, not by drawing position.

Main components on the Anden dcc

Anden dcc bill of materials (BOM)

21 components, 18 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
SN74AHCT125N
U1
1
Raspberry Pi Pico W
M1
1
Deek-Robot L298P / A only
M2
1
USB-C PD / 15 V, >=3 A
M3
1
MP1584 / SET 5.00 V
M4
1
TRACK 1
J1
1
TRACK 2
J2
1
3 A / >=32 V DC
F1
1
TRACK POWER / OFF
S1
1
1N5819 / band to VSYS
D1
1
100 uF / 25 V
C1
1
47 uF / >=10 V
C2
1
100 nF / U1
C3
1
100 nF / shield
C4
1
100 nF / Pico VSYS
C5
1
1 nF
C6
3
10k
R1, R2, R3
2
10k 1%
R4, R5

Anden dcc design files

The KiCad project lives in the laullon/anden-dcc repository on GitHub; these links point at the commit this page was built from.

Anden dcc: common questions

What microcontroller does the Anden dcc use?

The Anden dcc is built around the Raspberry Pi Pico W, from the RP2040/RP2350 family.

How many components are on the Anden dcc?

21 components, from 18 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Anden dcc design files?

From the laullon/anden-dcc repository on GitHub, which has the schematic, a netlist and the BOM; the links under Design files point to each one.

Can I use the Anden dcc design in my own project?

Yes, under the terms of its MIT license, which laullon chose for the repository.

Can I test firmware for the Anden dcc without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards