MiniReader

Lumpkinn·MiniReader

MiniReader PCB layout, top view — open source RP2040/RP2350 board by Lumpkinn

About the MiniReader PCB

MiniReader is an open source RP2040/RP2350 PCB design by Lumpkinn, published on GitHub. It is a 2-layer board measuring 76.5 × 84.5 mm, with 5 components from 5 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. By type, the board carries 2 connectors, 1 module and 1 capacitor.

MiniReader, from the project README
From the project README

Main components on the MiniReader

MiniReader bill of materials (BOM)

5 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
RaspberryPi_Pico
A1
1
Conn_01x09
J1
1
Conn_01x06
J2
1
R_Potentiometer
RV1
1
10 µF
C2

MiniReader design files

The KiCad project lives in the Lumpkinn/MiniReader repository on GitHub; these links point at the commit this page was built from.

MiniReader: common questions

What microcontroller does the MiniReader use?

The MiniReader is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the MiniReader PCB?

The MiniReader measures 76.5 × 84.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MiniReader?

5 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the MiniReader design files?

From the Lumpkinn/MiniReader repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the MiniReader design in my own project?

The repository has no license, so all rights stay with Lumpkinn. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the MiniReader without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards