Parking status sensor

makeOurCity·parking-status-sensor·hardware/lte-power-switch/lte-power-switch.kicad_pcb

Parking status sensor PCB layout, top view — open source board by makeOurCity

About the Parking status sensor PCB

Parking status sensor is an open source PCB design by makeOurCity, published on GitHub. It is a 2-layer board measuring 38 × 28 mm, with 9 components from 7 distinct parts.

Other key parts include the TPS22918DBVR. By type, the board carries 3 connectors, 3 capacitors, 2 resistors and 1 IC.

It belongs with the iot & wireless and sensors designs in this gallery.

From the project

駐車場の満空表示灯の発光色をカラーセンサで外付け読み取りし、満空状態をIoTデータ化するPoC

状態: 暫定・WIP。rev A(2026-10-05 発注、2026-10-12 到着)は、Grove コネクタのピン番号が実物と鏡像のため、普通の Grove ケーブルでは使えない(下の「rev A の既知の不具合」)。このディレクトリの設計・製造データは、鏡像を直した rev B(2026-10-12 作成・発注)。 M5 Unit CatM(LTE-M)の VCC 線を TI TPS22918DBVR で開閉する、Grove コネクタ 3 つの小基板。設計の背景は ../../docs/88-load-switch-design.md。

Grove の pin1 = 黄、pin2 = 白、pin3 = 赤、pin4 = 黒。物理的なパッドの並びは、三角(J1 は▼、J2 は▲、J3 は▶)のパッドから順に、pin4(黒・GND)、pin3(赤)、pin2(白)、pin1(黄)(下の「rev B」の表)。基板は 38 × 28mm、2 層、1.6mm。部品はすべて表面(JLCPCB の片面実装)。

Main components on the Parking status sensor

Parking status sensor bill of materials (BOM)

9 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TPS22918DBVR
U1
3
HY2.0-4P-WT
J1, J2, J3
1
1UF
1uF
C1
1
1NF
1nF
C2
1
10uF
C3
1
100K
100k
R1
1
DNP
R2

Parking status sensor design files

The KiCad project lives in the makeOurCity/parking-status-sensor repository on GitHub; these links point at the commit this page was built from.

Parking status sensor: common questions

How big is the Parking status sensor PCB?

The Parking status sensor measures 38 × 28 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Parking status sensor?

9 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Parking status sensor design files?

From the makeOurCity/parking-status-sensor repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Parking status sensor design in my own project?

The repository has no license, so all rights stay with makeOurCity. Use it as a reference, and ask the author before reusing the design.

Similar boards