HardLabs

Mcu gesture control board

NB6RULES·Nadec-Biju-Fabacademy-Files·week-9/gesture control board/mcu gesture control board.kicad_pcb

Mcu gesture control board layout, top view — open source AVR/Arduino board by NB6RULES

About the Mcu gesture control board

Mcu gesture control board is an open source AVR/Arduino PCB design by NB6RULES, published on GitHub. It is a 2-layer board measuring 35.5 × 30.5 mm, with 12 components from 9 distinct parts.

Its main chip is the ATtiny1624-SS, from the AVR/Arduino family. Other key parts include the AMS1117. By type, the board carries 3 connectors, 3 capacitors, 2 ICs, 2 diodes and 2 resistors.

Main components on the Mcu gesture control board

ATtiny1624-SSAMS1117

Mcu gesture control board bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
ATtiny1624-SS
U1
1
AMS1117
U2
1
Conn_PinHeader_FTDI_1x06_P2.54mm_Horizontal_SMD
J4
1
I2C JST
J5
1
PinHeader_01x06_P2.54mm_Horizontal_SMD
J6
2
LED_1206
D1, D2
2
10uF
C1, C2
1
100nF
C3
2
R_1206
R1, R2

Mcu gesture control board design files

The KiCad project lives in the NB6RULES/Nadec-Biju-Fabacademy-Files repository on GitHub; these links point at the commit this page was built from.

Mcu gesture control board: common questions

What microcontroller does the Mcu gesture control board use?

The Mcu gesture control board is built around the ATtiny1624-SS, from the AVR/Arduino family.

How big is the Mcu gesture control board?

The Mcu gesture control board measures 35.5 × 30.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Mcu gesture control board?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Mcu gesture control board design files?

From the NB6RULES/Nadec-Biju-Fabacademy-Files repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Mcu gesture control board design in my own project?

The repository has no license, so all rights stay with NB6RULES. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Mcu gesture control board without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Nadec-Biju-Fabacademy-Files

Similar boards