Dew connector

ncleesattel·ESP32_DewHeater·hardware/dew_connector_pcb/dew_connector_pcb.kicad_pcb

Dew connector PCB layout, top view — open source board by ncleesattel

About the Dew connector PCB

Dew connector is an open source PCB design by ncleesattel, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 120 × 26 mm, with 13 components from 4 distinct parts.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

ESP32 open-loop dew heater

Best case 170 Eur if you can share all pcbs Worst case 320 Eur if you keep all pcbs and build only one

Dew connector, from the project README
From the project README

Dew connector bill of materials (BOM)

13 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
7
Barrel_Jack_MountingPin
J10, J11, J20, J21, J22, J23, J30
2
Conn_01x02
J12, J31
1
Conn_01x04
J40
3
Conn_01x02
J41, J42, J43

Dew connector design files

The KiCad project lives in the ncleesattel/ESP32_DewHeater repository on GitHub; these links point at the commit this page was built from.

Dew connector: common questions

How big is the Dew connector PCB?

The Dew connector measures 120 × 26 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Dew connector?

13 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Dew connector design files?

From the ncleesattel/ESP32_DewHeater repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Dew connector design in my own project?

Yes, under the terms of its GPL-3.0 license, which ncleesattel chose for the repository.

More boards in ESP32_DewHeater

Similar boards