Dew sensor

ncleesattel·ESP32_DewHeater·hardware/dew_sensor_pcb/dew_sensor_pcb.kicad_pcb

Dew sensor PCB layout, top view — open source board by ncleesattel

About the Dew sensor PCB

Dew sensor is an open source PCB design by ncleesattel, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 120 × 20 mm, with 8 components from 5 distinct parts.

By type, the board carries 7 connectors and 1 switch.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

ESP32 open-loop dew heater

Best case 170 Eur if you can share all pcbs Worst case 320 Eur if you keep all pcbs and build only one

Dew sensor, from the project README
From the project README

Dew sensor bill of materials (BOM)

8 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
CONN_01X02
Conn_01x02
J1, J2
2
CONN_01X03
Conn_01x03
J4, J6
2
CONN_01X03
Conn_01x03
J5, J7
1
Barrel_Jack_MountingPin
J8
1
SW_SPST
SW1

Dew sensor design files

The KiCad project lives in the ncleesattel/ESP32_DewHeater repository on GitHub; these links point at the commit this page was built from.

Dew sensor: common questions

How big is the Dew sensor PCB?

The Dew sensor measures 120 × 20 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Dew sensor?

8 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Dew sensor design files?

From the ncleesattel/ESP32_DewHeater repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Dew sensor design in my own project?

Yes, under the terms of its GPL-3.0 license, which ncleesattel chose for the repository.

More boards in ESP32_DewHeater

Similar boards