HardLabs

Scoopy node

NiceHatThanks·scoopy-node·hardware/kicad/scoopy/scoopy.kicad_pcb

Scoopy node PCB layout, top view — open source ESP32 board by NiceHatThanks
Simulate this board

About the Scoopy node PCB

Scoopy node is an open source ESP32 PCB design by NiceHatThanks, published on GitHub under the Custom license license. It is a 2-layer board measuring 28 × 28 mm, with 11 components from 7 distinct parts.

Its main chip is the ESP32_SuperMini, from the ESP32 family. By type, the board carries 3 connectors, 3 diodes, 3 resistors and 2 switches.

From the project

Electrical design and manufacturing files for Scoopy Node.

Electrical design and manufacturing files for Scoopy Node.

- kicad/scoopy/ — editable KiCad project source - gerbers/v1/ — V1 fabrication-ready Gerber and drill files - gerbers/V1-Gerbers.zip — upload-ready V1 Gerber archive - bom/v1/ — V1 bill of materials and manufacturing exports

The KiCad directory contains the editable design source. Generated fabrication outputs live separately so the project stays clean and manufacturing files are easy to identify.

Scoopy node bill of materials (BOM)

11 components, 7 distinct parts.

QtyPartRefs
1
ESP32_SuperMini
J1
1
C19723500
LD2410C
J2
1
Conn_01x04_Pin
J3
2
C879462
SW_Push
E-SWITCH
SW1, SW2
2
C22371297
LED - Green
MULTICOMP PRO
D1, D2
1
C19171390
LED - Red
MULTICOMP PRO
D3
3
C2907005
2.2k
BOURNS
R1, R2, R3

Scoopy node design files

The KiCad project lives in the NiceHatThanks/scoopy-node repository on GitHub; these links point at the commit this page was built from.

Scoopy node: common questions

What microcontroller does the Scoopy node use?

The Scoopy node is built around the ESP32_SuperMini, from the ESP32 family.

How big is the Scoopy node PCB?

The Scoopy node measures 28 × 28 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Scoopy node?

11 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Scoopy node design files?

From the NiceHatThanks/scoopy-node repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Scoopy node design in my own project?

It is published under Custom license, which limits how it may be reused; read the license before building on it.

Can I test firmware for the Scoopy node without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards