Ice dip

Pixoled·ice-dip·pcb/ice-dip.kicad_pcb

Ice dip PCB layout, top view — open source FPGA board by Pixoled

About the Ice dip PCB

Ice dip is an open source FPGA PCB design by Pixoled, published on GitHub. It is a 4-layer board measuring 17.8 × 50.8 mm, with 39 components from 13 distinct parts.

Its main chip is the ICE40UP5K-SG48ITR50, from the FPGA family. Other key parts include the W25Q16JVSNIQ, LDL1117S33R, MCP1700T-1202E/TT and SN74CBTD3861PWR. By type, the board carries 21 capacitors, 8 ICs, 7 resistors, 2 connectors and 1 crystal.

From the project

An iCE40 UltraPlus 5K FPGA board on a DIP-40 sized board.

This is a small FPGA board containing the Lattice iCE40 UltraPlus 5K FPGA.

NOTE: At this moment this design is untested.

Ice dip, from the project README
From the project README

Main components on the Ice dip

Ice dip bill of materials (BOM)

39 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ICE40UP5K-SG48ITR50
U1
1
W25Q16JVSNIQ
U2
1
LDL1117S33R
U3
1
MCP1700T-1202E/TT
U4
4
SN74CBTD3861PWR
U5, U6, U7, U8
1
SG-5032CAN
X1
1
Pin1-20
J1
1
Pin21-40
J2
13
100nF
C1, C2, C3, C4, C6, C7, C8, C11 +5
8
4.7uF
C5, C9, C10, C12, C20, C21, C27, C28
5
10k
R1, R2, R3, R4, R6
1
100
R5
1
1
R42

Ice dip design files

The KiCad project lives in the Pixoled/ice-dip repository on GitHub; these links point at the commit this page was built from.

Ice dip: common questions

What microcontroller does the Ice dip use?

The Ice dip is built around the ICE40UP5K-SG48ITR50, from the FPGA family.

How big is the Ice dip PCB?

The Ice dip measures 17.8 × 50.8 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Ice dip?

39 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Ice dip design files?

From the Pixoled/ice-dip repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Ice dip design in my own project?

The repository has no license, so all rights stay with Pixoled. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Ice dip without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug FPGA firmware against it before you order a PCB.

Similar boards