HardLabs

Door v1.3

pmacik·electronics·KiCad/devconf2015-door/door_v1.3.kicad_pcb

Door v1.3 PCB layout, top view — open source AVR/Arduino board by pmacik

About the Door v1.3 PCB

Door v1.3 is an open source AVR/Arduino PCB design by pmacik, published on GitHub. It is a 2-layer board measuring 21.6 × 51.4 mm, with 19 components from 14 distinct parts.

Its main chip is the ARDUINO_MINI, from the AVR/Arduino family. By type, the board carries 6 connectors, 5 resistors, 3 capacitors, 2 switches, 2 diodes and 1 IC.

Main components on the Door v1.3

ARDUINO_MINI

Door v1.3 bill of materials (BOM)

19 components, 14 distinct parts.

QtyPartRefs
1
ARDUINO_MINI
U1
1
Cubieboard
P1
1
Servo
P2
1
Bell
P3
1
Door Open
P4
1
Servo PWR Jmpr
P5
1
Servo Ext PWR
P6
1
Emergency open
SW1
1
Bell Test
SW2
1
RED_LED
D1
1
GREEN_LED
D2
3
100nF
C1, C2, C3
2
R
R1, R2
3
1M
R3, R4, R5

Door v1.3 design files

The KiCad project lives in the pmacik/electronics repository on GitHub; these links point at the commit this page was built from.

Door v1.3: common questions

What microcontroller does the Door v1.3 use?

The Door v1.3 is built around the ARDUINO_MINI, from the AVR/Arduino family.

How big is the Door v1.3 PCB?

The Door v1.3 measures 21.6 × 51.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Door v1.3?

19 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Door v1.3 design files?

From the pmacik/electronics repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Door v1.3 design in my own project?

The repository has no license, so all rights stay with pmacik. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Door v1.3 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in electronics

Similar boards