P1-The-Pathfinder-

RichardM-1337·P1-The-Pathfinder-·PCB/P1.kicad_pcb

P1-The-Pathfinder- PCB layout, top view — open source RP2040/RP2350 board by RichardM-1337

About the P1-The-Pathfinder- PCB

P1-The-Pathfinder- is an open source RP2040/RP2350 PCB design by RichardM-1337, published on GitHub under the MIT license. It is a 2-layer board measuring 64.2 × 46.6 mm, with 13 components from 4 distinct parts.

Its main chip is the XIAO-RP2040-DIP, from the RP2040/RP2350 family. By type, the board carries 4 switches, 4 diodes, 4 resistors and 1 IC.

It belongs with the keyboards designs in this gallery.

From the project

A simple 4 led and 4 key-switch pathfinder that allows my adhd to take over. :)

A pretty simple project that only takes 4-5 hours but allowed me to master the basics of pcb design better.

P1-The-Pathfinder-, from the project README
From the project README

Main components on the P1-The-Pathfinder-

P1-The-Pathfinder- bill of materials (BOM)

13 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-RP2040-DIP
U1
4
SW_Push
SW1, SW2, SW3, SW4
4
L08R5000Q1
D1, D2, D3, D4
4
R
R1, R2, R3, R4

P1-The-Pathfinder- design files

The KiCad project lives in the RichardM-1337/P1-The-Pathfinder- repository on GitHub; these links point at the commit this page was built from.

P1-The-Pathfinder-: common questions

What microcontroller does the P1-The-Pathfinder- use?

The P1-The-Pathfinder- is built around the XIAO-RP2040-DIP, from the RP2040/RP2350 family.

How big is the P1-The-Pathfinder- PCB?

The P1-The-Pathfinder- measures 64.2 × 46.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the P1-The-Pathfinder-?

13 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the P1-The-Pathfinder- design files?

From the RichardM-1337/P1-The-Pathfinder- repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the P1-The-Pathfinder- design in my own project?

Yes, under the terms of its MIT license, which RichardM-1337 chose for the repository.

Can I test firmware for the P1-The-Pathfinder- without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards