Usb power metering

ritonun·usb-power-metering·usb-power-metering-schematics/usb-power-metering-schematics.kicad_sch

This repository ships a schematic but no board layout.

About the Usb power metering PCB

Usb power metering is an open source AVR/Arduino PCB design by ritonun, published on GitHub. It is a board, with 16 components from 11 distinct parts.

Its main chip is the ATmega328P-P, from the AVR/Arduino family. Other key parts include the INA219AxD and HUSB238-DFN-10L. By type, the board carries 6 capacitors, 5 resistors, 3 ICs, 1 crystal and 1 connector.

From the project

Small USB power metering to monitor charging cycle of small electronics objects. Mostly made for my bicycle light.

Main components on the Usb power metering

INA219AxDATmega328P-PHUSB238-DFN-10L

Usb power metering bill of materials (BOM)

16 components, 11 distinct parts.

QtyPartRefs
1
INA219AxD
U1
1
ATmega328P-P
U2
1
HUSB238-DFN-10L
U3
1
16MHz
Y1
1
USB_C_Plug
P1
2
10uF
C1, C2
2
22pF
C3, C4
2
0.1uF
C5, C6
1
1k
R1
2
10k
R2, R3
2
10
R4, R5

Usb power metering design files

The KiCad project lives in the ritonun/usb-power-metering repository on GitHub; these links point at the commit this page was built from.

Usb power metering: common questions

What microcontroller does the Usb power metering use?

The Usb power metering is built around the ATmega328P-P, from the AVR/Arduino family.

How many components are on the Usb power metering?

16 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Usb power metering design files?

From the ritonun/usb-power-metering repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Usb power metering design in my own project?

The repository has no license, so all rights stay with ritonun. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Usb power metering without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards