HardLabs

Flight-Controller

RNA-IITPatna·Flight-Controller·Version 1.0/PCB-Design/KiCAD Files/PCB-Design.kicad_pcb

Flight-Controller PCB layout, top view — open source AVR/Arduino board by RNA-IITPatna

About the Flight-Controller PCB

Flight-Controller is an open source AVR/Arduino PCB design by RNA-IITPatna, published on GitHub. It is a 2-layer board measuring 40 × 100 mm, with 27 components from 21 distinct parts.

Its main chip is the ATmega328P-P, from the AVR/Arduino family. Other key parts include the L7805. By type, the board carries 14 connectors, 7 capacitors, 2 ICs, 2 resistors, 1 crystal and 1 diode.

It belongs with the robotics & motion designs in this gallery.

From the project

Code related to flight controller for RNA's model rockets

Main components on the Flight-Controller

ATmega328P-PL7805

Flight-Controller bill of materials (BOM)

27 components, 21 distinct parts.

QtyPartRefs
1
ATmega328P-P
U1
1
L7805
U2
1
16MHz
Y1
1
I2C_1
J1
1
UART
J2
1
Barrel_Jack_Switch
J3
1
Screw_Terminal_01x02
J4
1
BMP - 280
J5
1
MPU - 6050
J6
1
SEN - 0409
J7
1
SPI_1
J8
1
A2_3
J9
1
D5_6_7
J10
1
MicroSD Reader
J11
1
9V
J12
2
5V
J13, J14
1
LED
D1
2
22nF
C1, C2
5
100nF
C3, C4, C5, C6, C7
1
1K
R1
Show 1 more
QtyPartRefs
1
10K
R2

Flight-Controller design files

The KiCad project lives in the RNA-IITPatna/Flight-Controller repository on GitHub; these links point at the commit this page was built from.

Flight-Controller: common questions

What microcontroller does the Flight-Controller use?

The Flight-Controller is built around the ATmega328P-P, from the AVR/Arduino family.

How big is the Flight-Controller PCB?

The Flight-Controller measures 40 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Flight-Controller?

27 components, from 21 distinct parts. The full bill of materials is listed on this page.

Where can I download the Flight-Controller design files?

From the RNA-IITPatna/Flight-Controller repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Flight-Controller design in my own project?

The repository has no license, so all rights stay with RNA-IITPatna. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Flight-Controller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards