Receiver

rubaiyat666·Ghost-1·Kicad/receiver/receiver.kicad_pcb

Receiver PCB layout, top view — open source AVR/Arduino board by rubaiyat666

About the Receiver PCB

Receiver is an open source AVR/Arduino PCB design by rubaiyat666, published on GitHub under the MIT license. It is a 2-layer board measuring 29.5 × 71.5 mm, with 10 components from 7 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the LM1117T-2.5 and NRF24L01_Breakout. By type, the board carries 4 capacitors, 3 connectors, 2 ICs and 1 module.

It belongs with the robotics & motion and rf & radio designs in this gallery.

From the project

A Drone made with a transceiver and flight controller that I made.

A Drone made with a transceiver and flight controller that I made. There is nothing much to say about this because it speaks for itself. Well it's ment to be fast. And one of the most fun thing about this is its fully diy. From the trasmitter to the flight controller. The firmware for the flight controller is from opensource Betaflight github.

This is the transmitter that's used. Checkout https://github.com/VampireBandit/Transceiver_101

Receiver, from the project README
From the project README

Main components on the Receiver

Receiver bill of materials (BOM)

10 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
LM1117T-2.5
U2
1
NRF24L01_Breakout
U3
1
Arduino_Nano_v3.x
A1
3
Conn_01x06_Pin
J1, J2, J3
2
100nf
C1, C2
1
100μf
C3
1
10μf
C4

Receiver design files

The KiCad project lives in the rubaiyat666/Ghost-1 repository on GitHub; these links point at the commit this page was built from.

Receiver: common questions

What microcontroller does the Receiver use?

The Receiver is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Receiver PCB?

The Receiver measures 29.5 × 71.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Receiver?

10 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Receiver design files?

From the rubaiyat666/Ghost-1 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Receiver design in my own project?

Yes, under the terms of its MIT license, which rubaiyat666 chose for the repository.

Can I test firmware for the Receiver without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Ghost-1

Similar boards