HardLabs

Kicad sailframes e1

sailframes·core·edge-e/hardware/kicad_sailframes-e1.kicad_pcb

Kicad sailframes e1 PCB layout, top view — open source ESP32 board by sailframes
Simulate this board

About the Kicad sailframes e1 PCB

Kicad sailframes e1 is an open source ESP32 PCB design by sailframes, published on GitHub under the Apache-2.0 license. It is a 2-layer board measuring 60.5 × 91.5 mm, with 17 components from 10 distinct parts.

Its main chip is the ESP32DEVIKITV1, from the ESP32 family. Other key parts include the Hosyond_3.5_ST7796U. By type, the board carries 10 connectors, 4 resistors, 2 ICs and 1 switch.

From the project

ESP32-based edge device for sailboat racing data acquisition.

ESP32-based edge device for sailboat racing data acquisition.

Part of sailframes/core. See edge-s for Raspberry Pi-based device.

- E1 - First generation ESP32 device (current)

Build and flash using Arduino IDE or PlatformIO:

Main components on the Kicad sailframes e1

Hosyond_3.5_ST7796U

Kicad sailframes e1 bill of materials (BOM)

17 components, 10 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
~
U1
1
Hosyond_3.5_ST7796U
U2
1
Conn_01x06
J1
6
Conn_01x04
J2, J4, J5, J6, J7, J8
1
Conn_01x10
J3
1
Conn_01x06
J9
1
Conn_01x02
J10
1
SW_SPDT
SW1
2
100K
R1, R2
2
4.7K
R3, R4

Kicad sailframes e1 design files

The KiCad project lives in the sailframes/core repository on GitHub; these links point at the commit this page was built from.

Kicad sailframes e1: common questions

What microcontroller does the Kicad sailframes e1 use?

The Kicad sailframes e1 is built around the ESP32DEVIKITV1, from the ESP32 family.

How big is the Kicad sailframes e1 PCB?

The Kicad sailframes e1 measures 60.5 × 91.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Kicad sailframes e1?

17 components, from 10 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Kicad sailframes e1 design files?

From the sailframes/core repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Kicad sailframes e1 design in my own project?

Yes, under the terms of its Apache-2.0 license, which sailframes chose for the repository.

Can I test firmware for the Kicad sailframes e1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in core

Similar boards