Avionics breakout

scottzach1·Project-Beans·hardware_package/avionics_pcb/avionics_breakout_pcb/avionics_breakout_PCB.kicad_pcb

Avionics breakout layout, top view — open source board by scottzach1

About the Avionics breakout

Avionics breakout is an open source PCB design by scottzach1, published on GitHub under the MIT license. It is a 2-layer board measuring 98 × 27.9 mm, with 6 components from 6 distinct parts.

By type, the board carries 1 connector and 1 switch.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

VUW Engineering project to deliver a model rocket for a client.

This PCB is the second iteration of the avionics PCB, and is designed to interface the FeatherSTM with the MPU605 IMU, MPL3115A2 Barometer, and RFM98 LoRa module. This PCB is also design to breakout the UART serial connection needed for the GPS, as well as connections to the gimbal servos and 4 ignition lines.

This PCB is designed to be milled, and is therefor almost completely single sided. There will however need to be one mod wire connected if this PCB is milled on one side, which will connect the LoRa interrupt line to the interrupt pin.

Avionics breakout, from the project README
From the project README

Avionics breakout bill of materials (BOM)

6 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
GPS
J3
1
MPL3115A2-Adafruit
Barometer1
1
MPU-6050-Adafruit
IMU1
1
RFM98
LoRa_Radio1
1
Adafruit_Feather_STM32F405
STM32
1
SW_Push
SW1

Avionics breakout design files

The KiCad project lives in the scottzach1/Project-Beans repository on GitHub; these links point at the commit this page was built from.

Avionics breakout: common questions

How big is the Avionics breakout?

The Avionics breakout measures 98 × 27.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Avionics breakout?

6 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Avionics breakout design files?

From the scottzach1/Project-Beans repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Avionics breakout design in my own project?

Yes, under the terms of its MIT license, which scottzach1 chose for the repository.

More boards in Project-Beans

Similar boards