Tinnitus

Servacek·tinytus·hardware/usb-adc-dac-converter-switch/tinnitus.kicad_pcb

Tinnitus PCB layout, top view — open source AVR/Arduino board by Servacek

About the Tinnitus PCB

Tinnitus is an open source AVR/Arduino PCB design by Servacek, published on GitHub. It is a 2-layer board measuring 39.8 × 51.5 mm, with 10 components from 8 distinct parts.

Its main chip is the TLV75533PDBV, from the AVR/Arduino family. By type, the board carries 5 resistors, 2 diodes, 2 capacitors and 1 IC.

It belongs with the audio and rf & radio designs in this gallery.

From the project

Tiny C99 library which allows you to use existing audio channels for digital transmission. The project was presented and defended at the national round of the SOČ competition and at the TMR UNIZA competition.

Small, modular C99 library for transmitting digital data over acoustic channels using FSK modulation. Targets desktop (Windows, Linux), WebAssembly, and embedded platforms.

- GFSK modulation - configurable bits-per-symbol (1, 2, 4, 8), frequency range, sample rate and symbol rate - Reed-Solomon ECC - configurable error correction percentage per frame - DSS scrambling - optional data scrambling before encoding - AGC - automatic gain control on the receive path - Sync detection - marker-based start/end-of-frame detection - Builds as an executable, static lib, DLL, or WASM module - PortAudio…

Tinnitus, from the project README
From the project README

Main components on the Tinnitus

Tinnitus bill of materials (BOM)

10 components, 8 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TLV75533PDBV
ATtiny85-20P
U1
2
3V3
D1, D2
2
1UF
100nF
C1, C2
1
5K1
10K
R1
1
47R
2K2
R2
1
47R
27R
R3
1
10K
2K2
R4
1
220R
27R
R5

Tinnitus design files

The KiCad project lives in the Servacek/tinytus repository on GitHub; these links point at the commit this page was built from.

Tinnitus: common questions

What microcontroller does the Tinnitus use?

The Tinnitus is built around the TLV75533PDBV, from the AVR/Arduino family.

How big is the Tinnitus PCB?

The Tinnitus measures 39.8 × 51.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Tinnitus?

10 components, from 8 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Tinnitus design files?

From the Servacek/tinytus repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Tinnitus design in my own project?

The repository has no license, so all rights stay with Servacek. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Tinnitus without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in tinytus

Similar boards