HardLabs

Arduino uno pet puller

sh123·arduino_uno_pet_puller·extras/schematics/pet_puller_shield/pet_puller_shield.kicad_pcb

Arduino uno pet puller PCB layout, top view — open source AVR/Arduino board by sh123

About the Arduino uno pet puller PCB

Arduino uno pet puller is an open source AVR/Arduino PCB design by sh123, published on GitHub under the GPL-2.0 license. It is a 2-layer board measuring 75.4 × 53.9 mm, with 20 components from 15 distinct parts.

Its main chip is the Arduino_UNO_R2, from the AVR/Arduino family. Other key parts include the LM317_TO-220 and MX1508_module. By type, the board carries 6 connectors, 6 resistors, 2 ICs, 2 diodes, 1 module and 1 transistor.

It belongs with the dev boards & breakouts and robotics & motion designs in this gallery.

From the project

Alternative Arduino UNO based shield and firmware for Petalot

For more information about Petalot and its construction read at https://github.com/function3d/petalot.

This alternative board version based on parts and components found in a junk box, such as old Arduino UNO/Duemilanove, MX1508 stepper controller, external 12-13V power suppply, EM257 stepper from old printer, unlike origintal version it does not use WiFi remote control.

Main components on the Arduino uno pet puller

LM317_TO-220MX1508_moduleArduino_UNO_R2

Arduino uno pet puller bill of materials (BOM)

20 components, 15 distinct parts.

QtyPartRefs
1
LM317_TO-220
U1
1
MX1508_module
U2
1
Arduino_UNO_R2
A1
1
IRF540N
Q1
1
Jack-DC
J1
3
Conn_01x02
J2, J3, J6
1
Conn_01x02
J4
1
Conn_01x04
J5
1
1k
RV1
1
LED_Small
D1
1
1N5402
D2
1
220u
C1
3
10k
R1, R3, R5
2
220
R2, R6
1
240
R4

Arduino uno pet puller design files

The KiCad project lives in the sh123/arduino_uno_pet_puller repository on GitHub; these links point at the commit this page was built from.

Arduino uno pet puller: common questions

What microcontroller does the Arduino uno pet puller use?

The Arduino uno pet puller is built around the Arduino_UNO_R2, from the AVR/Arduino family.

How big is the Arduino uno pet puller PCB?

The Arduino uno pet puller measures 75.4 × 53.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Arduino uno pet puller?

20 components, from 15 distinct parts. The full bill of materials is listed on this page.

Where can I download the Arduino uno pet puller design files?

From the sh123/arduino_uno_pet_puller repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Arduino uno pet puller design in my own project?

Yes, under the terms of its GPL-2.0 license, which sh123 chose for the repository.

Can I test firmware for the Arduino uno pet puller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards