74hc165-module

shubham0x13·74hc165-module

74hc165-module layout, top view — open source board by shubham0x13

About the 74hc165-module

74hc165-module is an open source PCB design by shubham0x13, published on GitHub under the CERN-OHL-S-2.0 license. It is a 2-layer board measuring 35 × 35 mm, with 15 components from 5 distinct parts.

Other key parts include the 74HC165. By type, the board carries 9 resistors, 4 connectors, 1 IC and 1 capacitor.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

A compact, daisy-chainable breakout module for the 74HC165 8-bit shift register.

A simple, compact, daisy-chainable breakout module based on the 74HC165 8-bit parallel-in/serial-out shift register. It allows you to add digital inputs to any microcontroller in multiples of 8, using only 3 GPIO pins plus power and ground.

Inputs: 8 digital inputs via two 5-pin JST-XH headers (4 inputs + shared GND per header). Daisy-Chain: Connect modules in series to expand inputs in multiples of 8, sharing the same CLK, LOAD, VCC, and GND lines. Passives: Onboard 10 kΩ pull-ups on all inputs, a 100 kΩ pull-up on DIN (to ensure that if the MCU reads more bits than are physically…

74hc165-module, from the project README
From the project README

Main components on the 74hc165-module

74hc165-module bill of materials (BOM)

15 components, 5 distinct parts.

QtyPartRefs
1
74HC165
U1
4
Conn_01x05
J1, J2, J3, J4
1
100nF
C1
8
10K
R1, R2, R3, R4, R5, R6, R7, R8
1
100K
R9

74hc165-module design files

The KiCad project lives in the shubham0x13/74hc165-module repository on GitHub; these links point at the commit this page was built from.

74hc165-module: common questions

How big is the 74hc165-module?

The 74hc165-module measures 35 × 35 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the 74hc165-module?

15 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the 74hc165-module design files?

From the shubham0x13/74hc165-module repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the 74hc165-module design in my own project?

Yes, under the terms of its CERN-OHL-S-2.0 license, which shubham0x13 chose for the repository.

Similar boards