DK-SAO-BODGE

sphereinabox·2024-SAO-Shims·DK-SAO-BODGE/DK-SAO-BODGE.kicad_pcb

DK-SAO-BODGE PCB layout, top view — open source board by sphereinabox

About the DK-SAO-BODGE PCB

DK-SAO-BODGE is an open source PCB design by sphereinabox, published on GitHub. It is a 2-layer board measuring 17.8 × 23.5 mm, with 3 components from 3 distinct parts.

From the project

This SAO (SuperCon Add-On) shim goes between your badge and v1 of DigiKey SAO to swap the pin order and break out the pins for programming the SAMD11.

This SAO (SuperCon Add-On) shim goes between your badge and v1 of DigiKey SAO to swap the pin order and break out the pins for programming the SAMD11.

This was inspired by the DigiKey SAO which was built with the wrong connector on the SAO so pins were flipped, but also used the SAO pins as MCU programming pins.

DK-SAO-BODGE, from the project README
From the project README

DK-SAO-BODGE bill of materials (BOM)

3 components, 3 distinct parts.

QtyPartRefs
1
DK thing
J1
1
SAO
J2
1
Conn_01x06_Pin
J3

DK-SAO-BODGE design files

The KiCad project lives in the sphereinabox/2024-SAO-Shims repository on GitHub; these links point at the commit this page was built from.

DK-SAO-BODGE: common questions

How big is the DK-SAO-BODGE PCB?

The DK-SAO-BODGE measures 17.8 × 23.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the DK-SAO-BODGE?

3 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the DK-SAO-BODGE design files?

From the sphereinabox/2024-SAO-Shims repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the DK-SAO-BODGE design in my own project?

The repository has no license, so all rights stay with sphereinabox. Use it as a reference, and ask the author before reusing the design.

More boards in 2024-SAO-Shims