Microcomputer

stopnoanime·microcomputer·schematic/schematic.kicad_sch

Microcomputer

About the Microcomputer PCB

Microcomputer is an open source RP2040/RP2350 PCB design by stopnoanime, published on GitHub. It is a board, with 9 components from 8 distinct parts.

Its main chip is the Pico, from the RP2040/RP2350 family. By type, the board carries 3 connectors, 2 resistors, 1 IC, 1 buzzer, 1 switch and 1 diode.

It belongs with the power & battery designs in this gallery.

From the project

80s inspired portable microcomputer

The case is 3D printed in two parts, with total dimensions of 255x160x26mm. Unfortunately this is too big to print laying flat on a Ender 3, but with some extra supports you can print it vertically without any issue. The files to print are available in the stl folder.

This microcomputer uses Pico-PIO-USB to add a second HOST USB port that the keyboard is connected to internally. ## Parts list - Pi Pico or clone - 2.8" 320x240 TFT display module with ST7789 driver - USB keyboard taken out of a universal 10" tablet case (look for "universal usb keyboard 10" tablet case on eBay") - 1S LiPo…

Main components on the Microcomputer

Microcomputer bill of materials (BOM)

9 components, 8 distinct parts.

QtyPartRefs
1
Pico
U1
1
USB_Keyboard
J1
1
SD_CARD
J2
1
ST7789
J3
1
Buzzer
BZ1
1
POWER_SW
SW1
1
DIODE
D1
2
100K
R1, R2

Microcomputer design files

The KiCad project lives in the stopnoanime/microcomputer repository on GitHub; these links point at the commit this page was built from.

Microcomputer: common questions

What microcontroller does the Microcomputer use?

The Microcomputer is built around the Pico, from the RP2040/RP2350 family.

How many components are on the Microcomputer?

9 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Microcomputer design files?

From the stopnoanime/microcomputer repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Microcomputer design in my own project?

The repository has no license, so all rights stay with stopnoanime. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Microcomputer without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards