HardLabs

P300 Display IF

svenjust·room-ventilation-system·hardware/P300_Display_IF/P300_Display_IF.kicad_pcb

P300 Display IF PCB layout, top view — open source AVR/Arduino board by svenjust

About the P300 Display IF PCB

P300 Display IF is an open source AVR/Arduino PCB design by svenjust, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 64.8 × 50.8 mm, with 3 components from 3 distinct parts.

Its main chip is the Arduino_Mega2560_Shield_Display_MCU_Friends, from the AVR/Arduino family.

It belongs with the displays & leds designs in this gallery.

From the project

Arduino Projekt für ein Lüftungsgerät zur kontrollierten Wohnraum Lüftung (KWL)

Änderungen von HW-0.25 zu HW-0.26 - P300ArduinoIF - Korrektur externer Displayanschluss zum Arduino

Änderungen von HW-0.23 zu HW-0.26 - P300DisplayIF - Korrektur Displayanschluss zum Display

Änderungen von HW-0.23 zu HW-0.25 - P300ArduinoIF - Ergänzung von externen Pullup-Widerstand und Glättungskondensator am Tachosignal

Neu HW-0.25 - P300DiffPress - Entwurf einer Platine für den Aufbau von Differenzdrucksensoren

P300 Display IF bill of materials (BOM)

3 components, 3 distinct parts.

QtyPartRefs
1
TFT Display 1
J15
1
TFT Display 2
J16
1
Arduino_Mega2560_Shield_Display_MCU_Friends
XA1

P300 Display IF design files

The KiCad project lives in the svenjust/room-ventilation-system repository on GitHub; these links point at the commit this page was built from.

P300 Display IF: common questions

What microcontroller does the P300 Display IF use?

The P300 Display IF is built around the Arduino_Mega2560_Shield_Display_MCU_Friends, from the AVR/Arduino family.

How big is the P300 Display IF PCB?

The P300 Display IF measures 64.8 × 50.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the P300 Display IF?

3 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the P300 Display IF design files?

From the svenjust/room-ventilation-system repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the P300 Display IF design in my own project?

Yes, under the terms of its GPL-3.0 license, which svenjust chose for the repository.

Can I test firmware for the P300 Display IF without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in room-ventilation-system

Similar boards