HardLabs

DIYduino

szdiy·DIYduino·hardware/DIYduino.kicad_pcb

DIYduino PCB layout, top view — open source AVR/Arduino board by szdiy

About the DIYduino PCB

DIYduino is an open source AVR/Arduino PCB design by szdiy, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 68.6 × 53.3 mm, with 35 components from 24 distinct parts.

Its main chip is the ATmega32U4-AU, from the AVR/Arduino family. Other key parts include the NCP1117ST33T3G. By type, the board carries 9 resistors, 8 connectors, 8 capacitors, 4 diodes, 2 ICs and 1 crystal.

From the project

ChangeLog ------------ [Link][changelog]

ChangeLog ------------ [Link][changelog]

[schem]:https://github.com/danfei/DIYduino/raw/master/hardware/DIYduino.pdf [bom]:https://github.com/danfei/DIYduino/raw/master/hardware/manufature/DIYduino.csv [changelog]:https://github.com/danfei/DIYduino/blob/master/CHANGELOG.md

DIYduino, from the project README
From the project README

Main components on the DIYduino

ATmega32U4-AUNCP1117ST33T3G

DIYduino bill of materials (BOM)

35 components, 24 distinct parts.

QtyPartRefs
1
ATmega32U4-AU
U1
1
NCP1117ST33T3G
U2
1
16MHz
Y1
1
Power
P1
1
Analog
P2
1
Digital
P3
1
Digital
P4
4
CONN_1
P5, P6, P7, P8
1
USB_B
CONN1
1
ICSP
CONN2
1
SW_RESET
SW1
1
RX
D1
1
TX
D2
1
L
D3
1
ON
D4
2
22P
C1, C2
1
22uF
C3
2
100nF
C4, C5
1
1uF
C6
1
10uF/25V
C7
Show 4 more
QtyPartRefs
1
10uF
C8
2
10K
R1, R4
2
22R
R2, R3
5
1K
R5, R6, R7, R8, R9

DIYduino design files

The KiCad project lives in the szdiy/DIYduino repository on GitHub; these links point at the commit this page was built from.

DIYduino: common questions

What microcontroller does the DIYduino use?

The DIYduino is built around the ATmega32U4-AU, from the AVR/Arduino family.

How big is the DIYduino PCB?

The DIYduino measures 68.6 × 53.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the DIYduino?

35 components, from 24 distinct parts. The full bill of materials is listed on this page.

Where can I download the DIYduino design files?

From the szdiy/DIYduino repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the DIYduino design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which szdiy chose for the repository.

Can I test firmware for the DIYduino without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards