Dongle

tanu-loga·Dongle

Dongle PCB layout, top view — open source WCH CH32/CH55x board by tanu-loga

About the Dongle PCB

Dongle is an open source WCH CH32/CH55x PCB design by tanu-loga, published on GitHub. It is a 2-layer board measuring 27.5 × 68.5 mm, with 24 components from 7 distinct parts.

Its main chip is the CH552G, from the WCH CH32/CH55x family. By type, the board carries 10 resistors, 8 diodes, 2 switches, 2 capacitors, 1 IC and 1 connector.

From the project

My own LED Dongle

Dongle, from the project README
From the project README

Main components on the Dongle

Dongle bill of materials (BOM)

24 components, 7 distinct parts.

QtyPartRefs
1
CH552G
U1
1
USB_A
J1
2
SW_Push
SW1, SW2
8
LED
D1, D2, D3, D4, D5, D6, D7, D8
2
100nF
C1, C2
2
10K
R1, R7
8
330R
R2, R3, R4, R5, R6, R8, R9, R10

Dongle design files

The KiCad project lives in the tanu-loga/Dongle repository on GitHub; these links point at the commit this page was built from.

Dongle: common questions

What microcontroller does the Dongle use?

The Dongle is built around the CH552G, from the WCH CH32/CH55x family.

How big is the Dongle PCB?

The Dongle measures 27.5 × 68.5 mm, has 2 copper layers and is 2.09 mm thick.

How many components are on the Dongle?

24 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Dongle design files?

From the tanu-loga/Dongle repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Dongle design in my own project?

The repository has no license, so all rights stay with tanu-loga. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Dongle without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug WCH CH32/CH55x firmware against it before you order a PCB.

Similar boards