Pir

TheCacophonyProject·spool-pcb·pir/pir.kicad_pcb

Pir PCB layout, top view — open source board by TheCacophonyProject

About the Pir PCB

Pir is an open source PCB design by TheCacophonyProject, published on GitHub under the CERN-OHL-W-2.0 license. It is a 2-layer board measuring 60 × 45 mm, with 19 components from 9 distinct parts.

Other key parts include the BS612 and HT75xx-1-SOT89. By type, the board carries 7 resistors, 4 capacitors, 3 ICs, 2 connectors and 2 diodes.

From the project

- 2 x Crimped leads: 455-4118-ND Can chop in half and use 2 of the ends for the motor and 2 for the magnet - 1 x 8 Pin cable assembly 455-3842-ND for connecting main and plug board. - 3 x Protection Diodes SS54-HF to be hand soldered onto the plug board.

- 2 x Crimped leads: 455-4118-ND Can chop in half and use 2 of the ends for the motor and 2 for the magnet - 1 x 8 Pin cable assembly 455-3842-ND for connecting main and plug board. - 3 x Protection Diodes SS54-HF to be hand soldered onto the plug board.

- 2 x Photo interrupter DY-ITR8402 - 1 x 2 Pin JST XA housing XAP-02V-1 - 1 x 3 Pin JST XA housing XAP-03V-1 - 2 x 8 Pin JST XA Plug S08B-XASK-1(LF)(SN) - 1 x Magnet rotary position sensor? Not too sure if this will end up being used or not. AS5600-ASOT

Main components on the Pir

Pir bill of materials (BOM)

19 components, 9 distinct parts.

QtyPartRefs
2
BS612
U10, U12
1
HT75xx-1-SOT89
U11
2
Conn_01x03
J1, J2
1
10k
RV1
2
1N4148
D2, D3
2
1uF
C25, C26
2
100n
C28, C29
5
10k
R23, R24, R25, R27, R29
2
1k
R28, R30

Pir design files

The KiCad project lives in the TheCacophonyProject/spool-pcb repository on GitHub; these links point at the commit this page was built from.

Pir: common questions

How big is the Pir PCB?

The Pir measures 60 × 45 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pir?

19 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pir design files?

From the TheCacophonyProject/spool-pcb repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pir design in my own project?

Yes, under the terms of its CERN-OHL-W-2.0 license, which TheCacophonyProject chose for the repository.

More boards in spool-pcb