HardLabs

Uniclogs latching relay driver

uniclogs·uniclogs-hardware·eb-ground-station/rf-systems/components/rf-relay/uniclogs-latching-relay-driver.kicad_pcb

Uniclogs latching relay driver PCB layout, top view — open source board by uniclogs
Simulate this board

About the Uniclogs latching relay driver PCB

Uniclogs latching relay driver is an open source PCB design by uniclogs, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 25.4 × 30.5 mm, with 5 components from 4 distinct parts.

By type, the board carries 2 diodes, 1 connector and 1 capacitor.

It belongs with the rf & radio designs in this gallery.

From the project

University Class Open Ground Station Hardware

Antennas Feedlines Low Noise Amplifier Power Amplifier * Software Defined Radio (SDR)

Uniclogs latching relay driver bill of materials (BOM)

5 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
Conn_01x05
J1
1
MOV
RV1
2
S1G
D1, D2
1
C_Small
C1

Uniclogs latching relay driver design files

The KiCad project lives in the uniclogs/uniclogs-hardware repository on GitHub; these links point at the commit this page was built from.

Uniclogs latching relay driver: common questions

How big is the Uniclogs latching relay driver PCB?

The Uniclogs latching relay driver measures 25.4 × 30.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Uniclogs latching relay driver?

5 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Uniclogs latching relay driver design files?

From the uniclogs/uniclogs-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Uniclogs latching relay driver design in my own project?

Yes, under the terms of its GPL-3.0 license, which uniclogs chose for the repository.

More boards in uniclogs-hardware

Similar boards