HardLabs

ESP32-Camera

UnsignedArduino·ESP32-Camera-PCB

ESP32-Camera PCB layout, top view — open source ESP32 board by UnsignedArduino
Simulate this board

About the ESP32-Camera PCB

ESP32-Camera is an open source ESP32 PCB design by UnsignedArduino, published on GitHub. It is a 2-layer board measuring 94 × 114 mm, with 17 components from 15 distinct parts.

Its main chip is the ESP32_Dev_Board_Breakout, from the ESP32 family. By type, the board carries 5 switches, 2 resistors and 1 capacitor.

From the project

KiCad PCB files for my ESP32 Camera!

ESP32-Camera bill of materials (BOM)

17 components, 15 distinct parts.

QtyPartRefs
1
ST7735_160x128_TFT_Breakout
B1
1
ESP32_Dev_Board_Breakout
B2
1
Adafruit_MicroSD_Card_Breakout
B3
1
I2C_Level_Shifter_Breakout
B4
1
ArduCam_OV2640_Breakout
B5
1
RTC_Breakout
B6
1
PowerBoost_500_Breakout
B7
2
ESP32_Camera_Multi_PCB_pins
B8, B9
1
SW_DOWN
SW1
1
SW_SPDT
SW2
1
SW_SELECT
SW3
1
SW_UP
SW4
1
SW_SHUTTER
SW5
1
10uF
C1
2
100K
R1, R2

ESP32-Camera design files

The KiCad project lives in the UnsignedArduino/ESP32-Camera-PCB repository on GitHub; these links point at the commit this page was built from.

ESP32-Camera: common questions

What microcontroller does the ESP32-Camera use?

The ESP32-Camera is built around the ESP32_Dev_Board_Breakout, from the ESP32 family.

How big is the ESP32-Camera PCB?

The ESP32-Camera measures 94 × 114 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the ESP32-Camera?

17 components, from 15 distinct parts. The full bill of materials is listed on this page.

Where can I download the ESP32-Camera design files?

From the UnsignedArduino/ESP32-Camera-PCB repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the ESP32-Camera design in my own project?

The repository has no license, so all rights stay with UnsignedArduino. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ESP32-Camera without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards