Reelfoot rover

utm-lowe·reelfoot-rover

Reelfoot rover PCB layout, top view — open source board by utm-lowe

About the Reelfoot rover PCB

Reelfoot rover is an open source PCB design by utm-lowe, published on GitHub under the MIT license. It is a 2-layer board measuring 65 × 56 mm, with 26 components from 20 distinct parts.

Other key parts include the L293D and 7432. By type, the board carries 12 connectors, 9 capacitors, 3 ICs and 2 resistors.

It belongs with the robotics & motion designs in this gallery.

From the project

Circuit diagrams and source code for the Reelfoot Rover classroom robot.

The Reelfoot Rover is a robot which is used in the CSCI 458 - Autonomous Mobile Robotics at the University of Tennessee at Matin. This robot is a 4wd robot with each wheel being independantly controlled via PWM. The robot is controlled via a Raspberry Pi computer, and power for the motors and all peripherals is drawn from the power rails of the Raspberr Pi.

This repository contains the circuit board which controls the following: - 4 Independentally Controlled Motors - 4 Optical Wheel Encoders - 3 HC-SR04 Ultrasonic Range Finder (Sonars)

Main components on the Reelfoot rover

Reelfoot rover bill of materials (BOM)

26 components, 20 distinct parts.

QtyPartRefs
2
L293D
U1, U2
1
7432
U3
1
GPIO
J1
1
HC-SR04 1
J2
1
HC-SR04 2
J3
1
HC-SR04 3
J4
1
Encoder 1
J5
1
Encoder 2
J6
1
Encoder 3
J7
1
Encoder 4
J8
1
FL Motor
J9
1
FR Motor
J10
1
RL Motor
J11
1
RR Motor
J12
1
470 uF
C1
3
1 uF
C2, C4, C6
3
0.1 uF
C3, C5, C7
2
100 uF
C8, C9
1
330
R1
1
470
R2

Reelfoot rover design files

The KiCad project lives in the utm-lowe/reelfoot-rover repository on GitHub; these links point at the commit this page was built from.

Reelfoot rover: common questions

How big is the Reelfoot rover PCB?

The Reelfoot rover measures 65 × 56 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Reelfoot rover?

26 components, from 20 distinct parts. The full bill of materials is listed on this page.

Where can I download the Reelfoot rover design files?

From the utm-lowe/reelfoot-rover repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Reelfoot rover design in my own project?

Yes, under the terms of its MIT license, which utm-lowe chose for the repository.

Similar boards