83 open source boards using the L293D

Real designs built with the L293D, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

83 boardsClear filters|Most starred

How designs wire the L293D

Read from the KiCad layouts of 65 open source designs, one per repository: what each pin of the L293D connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 4, 5, 12, 13Connected to: GND 91%
VCC2pin 8Connected to: 12V 63% · a signal 35%
VCC1pin 16Connected to: 5V 77% · a signal 22%

10 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Line follower by thebiguno, Ultra DB X51 v1 by ExploreEmbedded, EnocderDriver by NikodemBartnik and 40pin AVRMCU by ExploreEmbedded.

The L293D in open source designs

The gallery holds 83 open source boards using the L293D from 67 GitHub repositories; a typical one measures about 86.4 × 71.8 mm and carries around 29 components.

90% are two-layer designs, the rest use four layers or more, and 24% carry an open source license.

The most starred is Line follower by thebiguno.

Microcontrollers on boards using the L293D

L293D: common questions

Where can I find a L293D reference design?

Each of the 83 boards on this page is a real design using the L293D. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the L293D?

The 24C16, 7805, DS1307, L7805 and LM7805_TO220 appear in the most repositories here.

Which microcontrollers do boards using the L293D use?

Most are built on AVR/Arduino (22), ESP32 (18), RP2040/RP2350 (3) and ESP8266 (3).

How big is a typical board using the L293D?

The median is 86.4 × 71.8 mm, and 90% are two-layer designs.

What is the most popular open source board using the L293D?

By GitHub stars, Line follower by thebiguno, with 75 stars.

Can I simulate one of these boards using the L293D before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part