BattleAxe

virajkhanna·BattleAxe·Schematics and PCBs/RC_Control_Files/RC_Control_Schematic.kicad_pcb

BattleAxe PCB layout, top view — open source AVR/Arduino board by virajkhanna

About the BattleAxe PCB

BattleAxe is an open source AVR/Arduino PCB design by virajkhanna, published on GitHub. It is a 2-layer board measuring 60 × 97 mm, with 17 components from 12 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the NRF24L01_Breakout and MCP1703Ax-330xxDB. By type, the board carries 4 switches, 3 capacitors, 3 resistors, 2 ICs, 2 connectors and 1 module.

It belongs with the robotics & motion and power & battery designs in this gallery.

From the project

A 4WD beetleweight battle robot built to fight opponents of a similar weight class.

A 4WD beetleweight battle robot built to fight opponents of a similar weight class.

This repository contains experimental and untested code and hardware schematics. Use them AT YOUR OWN RISK. The author assumes NO RESPONSIBILITY for ANY damage, data loss, or other issues that may arise from using this repository. By proceeding to do anything, you understand any action you perform is AT YOUR OWN RISK.

BattleAxe, from the project README
From the project README

Main components on the BattleAxe

BattleAxe bill of materials (BOM)

17 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
NRF24L01_Breakout
U2
1
MCP1703Ax-330xxDB
U4
1
Arduino_Nano_v3.x
A1
1
Conn_01x05_Pin
J1
1
Conn_01x04_Pin
J2
1
7.4V 18650 Battery 2200 mAh 2C
BT1
1
10A
F1
3
SW_Push
SW1, SW2, SW3
1
SW_SPST
SW4
1
10uF
C1
2
1uF
C2, C3
3
10K
R1, R2, R3

BattleAxe design files

The KiCad project lives in the virajkhanna/BattleAxe repository on GitHub; these links point at the commit this page was built from.

BattleAxe: common questions

What microcontroller does the BattleAxe use?

The BattleAxe is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the BattleAxe PCB?

The BattleAxe measures 60 × 97 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the BattleAxe?

17 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the BattleAxe design files?

From the virajkhanna/BattleAxe repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the BattleAxe design in my own project?

The repository has no license, so all rights stay with virajkhanna. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the BattleAxe without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards