Schematic mcp
vonpanda·schematic-mcp·examples/esp32_firmware_validation.kicad_sch
About the Schematic mcp PCB
Schematic mcp is an open source ESP32 PCB design by vonpanda, published on GitHub under the Apache-2.0 license. It is a board, with 3 components from 3 distinct parts.
Its main chip is the ESP32-Demo, from the ESP32 family. Other key parts include the I2C-Sensor. By type, the board carries 2 ICs and 1 diode.
From the project
MCP server that enables AI agents to understand, query, and reason over hardware schematics, components, nets, pins, and signal paths.
This directory contains small, synthetic schematics and firmware snippets that are safe to use in tests, demos, bug reports, and documentation.
Do not contribute proprietary customer schematics or files that contain confidential product information.
minimal.kicadsch` is a deliberately small KiCad schematic used by the automated tests. It demonstrates:
- two components; - a named SENSOROUT net; - a GND` net; - pin-to-net resolution; - signal tracing between endpoints.
Main components on the Schematic mcp
Schematic mcp bill of materials (BOM)
3 components, 3 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-Demo | U1 | |
| 1 | I2C-Sensor | U2 | |
| 1 | Status-LED | D1 |
Schematic mcp design files
The KiCad project lives in the vonpanda/schematic-mcp repository on GitHub; these links point at the commit this page was built from.
Schematic mcp: common questions
What microcontroller does the Schematic mcp use?
The Schematic mcp is built around the ESP32-Demo, from the ESP32 family.
How many components are on the Schematic mcp?
3 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Schematic mcp design files?
From the vonpanda/schematic-mcp repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.
Can I use the Schematic mcp design in my own project?
Yes, under the terms of its Apache-2.0 license, which vonpanda chose for the repository.
Can I test firmware for the Schematic mcp without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k