Keyboard-V1

Younesbahi·Keyboard-V1·PCB/Keyboard.kicad_pcb

Keyboard-V1 PCB layout, top view — open source RP2040/RP2350 board by Younesbahi

About the Keyboard-V1 PCB

Keyboard-V1 is an open source RP2040/RP2350 PCB design by Younesbahi, published on GitHub under the MIT license. It is a 2-layer board measuring 336.8 × 101.9 mm, with 136 components from 10 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. By type, the board carries 67 LEDs, 67 diodes and 1 module.

It belongs with the keyboards designs in this gallery.

From the project

My 60 ish Percent Keyboard to use till the day I die.

The keyboard uses a Raspberry Pi Pico microcontroller, a diode matrix, and a custom layout. It also has a 0.96-inch OLED screen.

Total Cost: $83.68 (Not including Case) | Schematic | PCB Layout | PCB render | |--------------|--------------|--------------| | | ||

Keyboard-V1, from the project README
From the project README

Main components on the Keyboard-V1

Keyboard-V1 bill of materials (BOM)

136 components, 10 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
RaspberryPi_Pico
A1
1
MX-NoLED
MX14
1
SSD1306
Brd1
51
MX-NoLED
MX1, MX2, MX3, MX4, MX5, MX6, MX7, MX8 +43
3
MX-NoLED
MX16, MX29, MX56
1
MX-NoLED
MX31
2
MX-NoLED
MX43, MX45
8
MX-NoLED
MX57, MX59, MX60, MX61, MX63, MX64, MX65, MX66
1
MX-NoLED
MX62
67
1N4148
D1, D2, D3, D4, D5, D6, D7, D8 +59

Keyboard-V1 design files

The KiCad project lives in the Younesbahi/Keyboard-V1 repository on GitHub; these links point at the commit this page was built from.

Keyboard-V1: common questions

What microcontroller does the Keyboard-V1 use?

The Keyboard-V1 is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the Keyboard-V1 PCB?

The Keyboard-V1 measures 336.8 × 101.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Keyboard-V1?

136 components, from 10 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Keyboard-V1 design files?

From the Younesbahi/Keyboard-V1 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Keyboard-V1 design in my own project?

Yes, under the terms of its MIT license, which Younesbahi chose for the repository.

Can I test firmware for the Keyboard-V1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards