Monitor

zincVTD·TPMS·Hardware/Monitor/Monitor/Monitor.kicad_pcb

Monitor PCB layout, top view — open source STM32 board by zincVTD

About the Monitor PCB

Monitor is an open source STM32 PCB design by zincVTD, published on GitHub. It is a 2-layer board measuring 62 × 35.4 mm, with 48 components from 34 distinct parts.

Its main chip is the STM32F042K6TX, from the STM32 family. Other key parts include the TPS54331DR and TJA1050T_CM_118. By type, the board carries 19 capacitors, 12 resistors, 6 connectors, 4 diodes, 3 ICs and 2 inductors.

Main components on the Monitor

Monitor bill of materials (BOM)

48 components, 34 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F042K6TX
STM32F042K6Tx
U1
1
TPS54331DR
U2
1
TJA1050T_CM_118
U3
1
16MHZ
16MHz
Y1
1
Boot
J1
1
CAN Bus
J2
1
UART Connector
J3
1
Vin
J4
1
SWD Connector
J5
1
OLED Connector
J6
1
SW_Push
SW1
1
LED_YELLOW
D1
1
LED_RED
D2
1
LED_GREEN
D3
1
SS34
D4
1
120R
FB1
1
10UH
10uH
L1
1
10U
10u
C1
6
100N
100n
C2, C4, C6, C7, C14, C19
2
10P
10p
C3, C5
Show 14 more
QtyPartRefs
2
1u
C8, C9
2
4.7U
4.7u
C10, C11
2
10N
10n
C12, C13
1
1n
C15
3
47P
47p
C16, C17, C18
3
1k
R2, R3, R13
1
330K
330k
R4
1
68K
68k
R5
1
120
R6
1
30K
30k
R7
1
0
R8
1
15K
15k
R9
1
4.7K
4.7k
R10
2
2.2K
2.2k
R11, R12

Monitor design files

The KiCad project lives in the zincVTD/TPMS repository on GitHub; these links point at the commit this page was built from.

Monitor: common questions

What microcontroller does the Monitor use?

The Monitor is built around the STM32F042K6TX, from the STM32 family.

How big is the Monitor PCB?

The Monitor measures 62 × 35.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Monitor?

48 components, from 34 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Monitor design files?

From the zincVTD/TPMS repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Monitor design in my own project?

The repository has no license, so all rights stay with zincVTD. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Monitor without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in TPMS

Similar boards