HardLabs

MRF-Pro v7.5-breakout

acornelissen·IDENTIDEM.design-MRF2·PCBs/v1.0/Breakout/KiCAD/MRF-Pro-v7.5-breakout.kicad_pcb

MRF-Pro v7.5-breakout layout, top view — open source board by acornelissen
Simulate this board

About the MRF-Pro v7.5-breakout

MRF-Pro v7.5-breakout is an open source PCB design by acornelissen, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 21 × 15.5 mm, with 3 components from 3 distinct parts.

It belongs with the dev boards & breakouts, displays & leds and power & battery designs in this gallery.

From the project

MRF2 is version two of an open hardware / open firmware medium-format rangefinder camera for Mamiya Press / Universal Press lenses. It combines custom PCBs, ESP32-S3 firmware, LiDAR-based lens coupled focusing, dual OLED displays, and printed mechanical parts so you can build a f

MRF2 is version two of an open hardware / open firmware medium-format rangefinder camera for Mamiya Press / Universal Press lenses. It combines custom PCBs, ESP32-S3 firmware, LiDAR-based lens coupled focusing, dual OLED displays, and printed mechanical parts so you can build a fully featured medium-format shooter with configurable lens profiles and film formats.

MRF-Pro v7.5-breakout, from the project README
From the project README

MRF-Pro v7.5-breakout bill of materials (BOM)

3 components, 3 distinct parts.

QtyPartRefs
1
FPC 8P Connector
J5
1
Stemma QT
J6
1
TFS20L / DTS6012M
J7

MRF-Pro v7.5-breakout design files

The KiCad project lives in the acornelissen/IDENTIDEM.design-MRF2 repository on GitHub; these links point at the commit this page was built from.

MRF-Pro v7.5-breakout: common questions

How big is the MRF-Pro v7.5-breakout?

The MRF-Pro v7.5-breakout measures 21 × 15.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MRF-Pro v7.5-breakout?

3 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the MRF-Pro v7.5-breakout design files?

From the acornelissen/IDENTIDEM.design-MRF2 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the MRF-Pro v7.5-breakout design in my own project?

Yes, under the terms of its GPL-3.0 license, which acornelissen chose for the repository.

More boards in IDENTIDEM.design-MRF2

Similar boards