2D-Matrix display

Adam-Primus·2D-Matrix-display·2D-Matrix-CAD/2D-Matrix-CAD.kicad_sch

2D-Matrix display

About the 2D-Matrix display PCB

2D-Matrix display is an open source ESP32 PCB design by Adam-Primus, published on GitHub under the MIT license. It is a board, with 47 components from 5 distinct parts.

Its main chip is the ESP32_30pin, from the ESP32 family. By type, the board carries 30 diodes, 11 resistors, 5 transistors and 1 IC.

It belongs with the displays & leds and iot & wireless designs in this gallery.

From the project

This project of mine is a 2 dimensional [i.e. x-axis, y-axis] LED Dot Matrix Display. It uses ESP32 microcontroller to control its output.

https://github.com/Adam-Primus/2D-Matrix-display/blob/main/BOM.csv

File Link:- https://github.com/Adam-Primus/2D-Matrix-display/tree/main/2D-Matrix-CAD

2D-Matrix display bill of materials (BOM)

47 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
—
U1
5
2N2219
Q1, Q2, Q3, Q4, Q5
30
LED
D1, D2, D3, D4, D5, D6, D7, D8 +22
5
1K Ω
R1, R2, R3, R4, R5
6
220 Ω
R6, R7, R8, R9, R10, R11

2D-Matrix display design files

The KiCad project lives in the Adam-Primus/2D-Matrix-display repository on GitHub; these links point at the commit this page was built from.

2D-Matrix display: common questions

What microcontroller does the 2D-Matrix display use?

The 2D-Matrix display is built around the ESP32_30pin, from the ESP32 family.

How many components are on the 2D-Matrix display?

47 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the 2D-Matrix display design files?

From the Adam-Primus/2D-Matrix-display repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.

Can I use the 2D-Matrix display design in my own project?

Yes, under the terms of its MIT license, which Adam-Primus chose for the repository.

Can I test firmware for the 2D-Matrix display without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards