MM01

adampisula·modmidi·boards/MM01/hardware/MM01.kicad_pcb

MM01 PCB layout, top view — open source board by adampisula

About the MM01 PCB

MM01 is an open source PCB design by adampisula, published on GitHub under the MIT license. It is a 2-layer board measuring 104.4 × 90 mm, with 93 components from 9 distinct parts.

Other key parts include the 74HC165 and 74HC14. By type, the board carries 37 resistors, 16 switches, 16 diodes, 16 capacitors, 5 ICs and 2 connectors.

From the project

MM01 is a 4×4 button and LED shield for the ModMIDI system. It does not contain its own MCU; its signals connect through MM00, whose STM32F103C8 runs any future MM01 firmware.

MM01 is a 4×4 button and LED shield for the ModMIDI system. It does not contain its own MCU; its signals connect through MM00, whose STM32F103C8 runs any future MM01 firmware.

Revision: 1, dated 2025-02-09 in the schematic title block.

- Sixteen TL1105 push buttons are scanned through two 74HC165 parallel-in/serial-out shift registers. - 74HC14 Schmitt-trigger logic conditions/debounces the button signals. - WS2813 addressable RGB LEDs form the LED array. - An AO3400A MOSFET provides the LED-data level-shifting stage between the controller logic and LED signal path. - The shield uses +5 V…

Main components on the MM01

MM01 bill of materials (BOM)

93 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
74HC165
U1, U2
3
74HC14
U3, U4, U5
1
AO3400A
Q1
2
01x13
J1, J2
16
SW_Push
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +8
16
WS2813
D1, D2, D3, D4, D5, D6, D7, D8 +8
16
470n
C1, C2, C3, C4, C5, C6, C7, C8 +8
21
10k
R1, R2, R3, R4, R5, R6, R11, R12 +13
16
5.1k
R7, R8, R9, R10, R13, R14, R16, R18 +8

MM01 design files

The KiCad project lives in the adampisula/modmidi repository on GitHub; these links point at the commit this page was built from.

MM01: common questions

How big is the MM01 PCB?

The MM01 measures 104.4 × 90 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MM01?

93 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the MM01 design files?

From the adampisula/modmidi repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the MM01 design in my own project?

Yes, under the terms of its MIT license, which adampisula chose for the repository.

More boards in modmidi