Meidi
adicoding-js·meidi
About the Meidi PCB
Meidi is an open source ESP32 PCB design by adicoding-js, published on GitHub. It is a 2-layer board measuring 115.5 × 104.5 mm, with 9 components from 7 distinct parts.
Its main chip is the Waveshare ESP32-S3-ZERO, from the ESP32 family. By type, the board carries 4 switches, 1 IC and 1 connector.
Main components on the Meidi
Meidi bill of materials (BOM)
9 components, 7 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Waveshare ESP32-S3-ZERO | Waveshare ESP32-S3-Zero | U1 |
| 1 | TOUCH_KEYS | capacitive | J1 |
| 1 | SLIDER1 | Potentiometer_Bourns_PTA1543_Single_Slide | RV1 |
| 1 | SLIDER2 | Potentiometer_Bourns_PTA1543_Single_Slide | RV2 |
| 1 | R_Potentiometer | Potentiometer_Alps_RK163_Single_Horizontal | RV3 |
| 3 | SW_Push | Kailh Choc Low-Profile Switches | SW1, SW2, SW3 |
| 1 | RotaryEncoder_Switch_MP | RotaryEncoder_Alps_EC11E-Switch_Vertical_H20mm | SW4 |
Meidi design files
The KiCad project lives in the adicoding-js/meidi repository on GitHub; these links point at the commit this page was built from.
- Layoutmeidi.kicad_pcb
- Schematicmeidi.kicad_sch
- BOMBOM.csv
Meidi: common questions
What microcontroller does the Meidi use?
The Meidi is built around the Waveshare ESP32-S3-ZERO, from the ESP32 family.
How big is the Meidi PCB?
The Meidi measures 115.5 × 104.5 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Meidi?
9 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Meidi design files?
From the adicoding-js/meidi repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Meidi design in my own project?
The repository has no license, so all rights stay with adicoding-js. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the Meidi without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k