HardLabs

Atmega remote

ArgonautGit·kicad-projects·Atmega_remote/Atmega_remote.kicad_pcb

Atmega remote PCB layout, top view — open source AVR/Arduino board by ArgonautGit

About the Atmega remote PCB

Atmega remote is an open source AVR/Arduino PCB design by ArgonautGit, published on GitHub. It is a 2-layer board measuring 32.5 × 24 mm, with 13 components from 8 distinct parts.

Its main chip is the ATmega328-A, from the AVR/Arduino family. By type, the board carries 5 resistors, 3 test points, 2 capacitors, 1 IC, 1 connector and 1 switch.

From the project

Just some Kicad projects I've worked on over the years. Most are unfinished or don't work well.

Main components on the Atmega remote

ATmega328-A

Atmega remote bill of materials (BOM)

13 components, 8 distinct parts.

QtyPartRefs
1
ATmega328-A
U1
1
Front Panel
J1
1
Tactile
SW1
1
PB0
TP0
1
PB1
TP1
1
PB2
TP2
2
100nF
C1, C2
5
3.3k
R1, R2, R3, R4, R5

Atmega remote design files

The KiCad project lives in the ArgonautGit/kicad-projects repository on GitHub; these links point at the commit this page was built from.

Atmega remote: common questions

What microcontroller does the Atmega remote use?

The Atmega remote is built around the ATmega328-A, from the AVR/Arduino family.

How big is the Atmega remote PCB?

The Atmega remote measures 32.5 × 24 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Atmega remote?

13 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Atmega remote design files?

From the ArgonautGit/kicad-projects repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Atmega remote design in my own project?

The repository has no license, so all rights stay with ArgonautGit. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Atmega remote without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in kicad-projects

Similar boards