HardLabs

Rain Gauge v0.6.2

ARTS-Laboratory·Rain-Gauge-Sensor-Package·Rain_Gauge/V0.6/v0.6.2/KiCad Files/Rain Gauge v0.6.2.kicad_pcb

Rain Gauge v0.6.2 PCB layout, top view — open source AVR/Arduino board by ARTS-Laboratory
Simulate this board

About the Rain Gauge v0.6.2 PCB

Rain Gauge v0.6.2 is an open source AVR/Arduino PCB design by ARTS-Laboratory, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 36.1 × 54.3 mm, with 11 components from 9 distinct parts.

Its main chip is the Arduino_Nano_Every, from the AVR/Arduino family. Other key parts include the Electrode, SD_Adapter, Lipo, MCP1825S and BME280. By type, the board carries 8 ICs, 1 module, 1 capacitor and 1 resistor.

It belongs with the sensors designs in this gallery, and the repository also holds 2 earlier revisions of it.

From the project

Measuring the rain

Main components on the Rain Gauge v0.6.2

ElectrodeSD_AdapterLipoMCP1825SBME280DS3231_ModuleArduino_Nano_Every

Rain Gauge v0.6.2 bill of materials (BOM)

11 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
Electrode
U1, U2
1
SD_Adapter
U3
1
Lipo
U4
2
MCP1825S
U5, U7
1
BME280
U6
1
DS3231_Module
U8
1
Arduino_Nano_Every
A1
1
C_Polarized
C1
1
R
R1

Rain Gauge v0.6.2 design files

The KiCad project lives in the ARTS-Laboratory/Rain-Gauge-Sensor-Package repository on GitHub; these links point at the commit this page was built from.

Rain Gauge v0.6.2: common questions

What microcontroller does the Rain Gauge v0.6.2 use?

The Rain Gauge v0.6.2 is built around the Arduino_Nano_Every, from the AVR/Arduino family.

How big is the Rain Gauge v0.6.2 PCB?

The Rain Gauge v0.6.2 measures 36.1 × 54.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Rain Gauge v0.6.2?

11 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Rain Gauge v0.6.2 design files?

From the ARTS-Laboratory/Rain-Gauge-Sensor-Package repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Rain Gauge v0.6.2 design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which ARTS-Laboratory chose for the repository.

Can I test firmware for the Rain Gauge v0.6.2 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Rain-Gauge-Sensor-Package

Earlier revisions in the repo: Rain Gauge v0.6.1, Rain Gauge

Similar boards