Pioneer3dx ROS2

AvansMechatronica·pioneer3dx_ROS2·kiCad/P3DX_Controller/P3DX_Controller.kicad_pcb

Pioneer3dx ROS2 PCB layout, top view — open source ESP32 board by AvansMechatronica

About the Pioneer3dx ROS2 PCB

Pioneer3dx ROS2 is an open source ESP32 PCB design by AvansMechatronica, published on GitHub under the Custom license license. It is a 2-layer board measuring 130 × 80 mm, with 20 components from 14 distinct parts.

Its main chip is the ESP32-S3-DevKitC, from the ESP32 family. Other key parts include the TXS0108EPW. By type, the board carries 6 connectors, 6 resistors, 4 ICs and 2 capacitors.

It belongs with the robotics & motion designs in this gallery.

Main components on the Pioneer3dx ROS2

Pioneer3dx ROS2 bill of materials (BOM)

20 components, 14 distinct parts.

QtyPartRefs
1
~
U1
1
TXS0108EPW
U2
1
ESP32-S3-DevKitC
U3
1
~
U4
2
Conn_01x10_Pin
J1, J3
1
Conn_01x26_Pin
J2
1
Conn_01x16_Pin
J4
1
Conn_01x03_Pin
J5
1
Conn_01x05_Pin
J6
2
100uF/10V
CP1, CP2
2
100nF
C1, C2
4
DO NOT PLACE
R1, R4, R5, R6
1
560k
R2
1
100k
R3

Pioneer3dx ROS2 design files

The KiCad project lives in the AvansMechatronica/pioneer3dx_ROS2 repository on GitHub; these links point at the commit this page was built from.

Pioneer3dx ROS2: common questions

What microcontroller does the Pioneer3dx ROS2 use?

The Pioneer3dx ROS2 is built around the ESP32-S3-DevKitC, from the ESP32 family.

How big is the Pioneer3dx ROS2 PCB?

The Pioneer3dx ROS2 measures 130 × 80 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pioneer3dx ROS2?

20 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pioneer3dx ROS2 design files?

From the AvansMechatronica/pioneer3dx_ROS2 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pioneer3dx ROS2 design in my own project?

It is published under Custom license, which limits how it may be reused; read the license before building on it.

Can I test firmware for the Pioneer3dx ROS2 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards