HardLabs

Film-Scanner

ccyyturralde·Film-Scanner·pcb/film_scanner_controller.kicad_pcb

Film-Scanner PCB layout, top view — open source board by ccyyturralde

About the Film-Scanner PCB

Film-Scanner is an open source PCB design by ccyyturralde, published on GitHub under the MIT license. It is a 2-layer board measuring 70 × 60 mm, with 1 components from 1 distinct parts.

Other key parts include the CH224K.

It belongs with the robotics & motion and power & battery designs in this gallery.

From the project

Open Source 35mm filmscaner with raspberry pi and arduino and mirrorless camera

A simple, reliable motor controller board for the 35mm film scanner project.

- Dual Power Input: USB-C Power Delivery (12V) OR 12V DC barrel jack - NEMA 17 Stepper Support: Via A4988/DRV8825 driver module - Status LEDs: Power, 5V rail, USB-C PD status, motor activity - Arduino Interface: 4-pin header for Step, Dir, Enable, GND - 5V Output: For powering Arduino or other logic

Main components on the Film-Scanner

CH224K

Film-Scanner bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
CH224K
WCH
U1

Film-Scanner design files

The KiCad project lives in the ccyyturralde/Film-Scanner repository on GitHub; these links point at the commit this page was built from.

Film-Scanner: common questions

How big is the Film-Scanner PCB?

The Film-Scanner measures 70 × 60 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Film-Scanner?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Film-Scanner design files?

From the ccyyturralde/Film-Scanner repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Film-Scanner design in my own project?

Yes, under the terms of its MIT license, which ccyyturralde chose for the repository.

Similar boards