HardLabs

Garage door opener with dual relay output

d0n13·automation·pcb/garagedoor/garagedoor.kicad_pcb

Garage door opener with dual relay output PCB layout, top view — open source Raspberry Pi board by d0n13

About the Garage door opener with dual relay output PCB

Garage door opener with dual relay output is an open source Raspberry Pi PCB design by d0n13, published on GitHub under the MIT license. It is a 2-layer board measuring 65 × 30 mm, with 19 components from 10 distinct parts.

Its main chip is the Raspberry Pi Zero, from the Raspberry Pi family. By type, the board carries 7 resistors, 4 connectors, 3 diodes, 2 transistors and 2 relays.

From the project

Homebridge accessories

Garage door opener with dual relay output bill of materials (BOM)

19 components, 10 distinct parts.

QtyPartRefs
2
FDC6561AN
Q1, Q2
1
240AC
J1
1
Door Control
J2
1
AUX GPIO
J3
1
Raspberry Pi Zero
J4
2
EC2-5SNU
K1, K2
1
173010578
PS1
3
LED
D1, D2, D3
4
10k
R1, R2, R5, R6
3
55
R3, R4, R7

Garage door opener with dual relay output design files

The KiCad project lives in the d0n13/automation repository on GitHub; these links point at the commit this page was built from.

Garage door opener with dual relay output: common questions

What microcontroller does the Garage door opener with dual relay output use?

The Garage door opener with dual relay output is built around the Raspberry Pi Zero, from the Raspberry Pi family.

How big is the Garage door opener with dual relay output PCB?

The Garage door opener with dual relay output measures 65 × 30 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Garage door opener with dual relay output?

19 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Garage door opener with dual relay output design files?

From the d0n13/automation repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Garage door opener with dual relay output design in my own project?

Yes, under the terms of its MIT license, which d0n13 chose for the repository.

Can I test firmware for the Garage door opener with dual relay output without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

More boards in automation

Similar boards