Contapassi-V1

daniele-boerio·contapassi-V1·hardware/contapassi.kicad_pcb

Contapassi-V1 PCB layout, top view — open source board by daniele-boerio

About the Contapassi-V1 PCB

Contapassi-V1 is an open source PCB design by daniele-boerio, published on GitHub. It is a 4-layer board measuring 24 × 41 mm, with 27 components from 17 distinct parts.

Other key parts include the E73-2G4M08S1C, LSM6DSV16XTR, W25Q256JVEIQ and MCP73831T-2ATI/OT. By type, the board carries 10 capacitors, 8 resistors, 4 ICs, 2 diodes, 1 transistor and 1 crystal.

From the project

lib/ va dentro hardware/. KiCad risolve le librerie di progetto con ${KIPRJMOD}, che punta alla cartella del .kicadpro. Fuori da lì i percorsi si rompono appena sposti il progetto.

lib/ va dentro hardware/. KiCad risolve le librerie di progetto con ${KIPRJMOD}, che punta alla cartella del .kicadpro. Fuori da lì i percorsi si rompono appena sposti il progetto.

Un solo repo, non tre. Hardware, firmware e analisi cambiano insieme: se sposti un pin nello schematico devi toccare anche il firmware. Con repo separati quella correlazione si perde, e il CLAUDE.md andrebbe duplicato.

Main components on the Contapassi-V1

Contapassi-V1 bill of materials (BOM)

27 components, 17 distinct parts.

QtyPartRefs
1
E73-2G4M08S1C
U1
1
LSM6DSV16XTR
U2
1
W25Q256JVEIQ
U3
1
MCP73831T-2ATI/OT
U4
1
AO3401A
Q1
1
32.768kHz
Y1
1
PESD5V0S1BA
D1
1
rosso
D2
1
10uH
L1
2
18pF
C1, C2
1
47uF
C3
3
4.7uF
C4, C5, C10
4
100nF
C6, C7, C8, C9
4
10k
R1, R2, R3, R4
2
100k
R5, R8
1
20k
R6
1
1k
R7

Contapassi-V1 design files

The KiCad project lives in the daniele-boerio/contapassi-V1 repository on GitHub; these links point at the commit this page was built from.

Contapassi-V1: common questions

How big is the Contapassi-V1 PCB?

The Contapassi-V1 measures 24 × 41 mm, has 4 copper layers and is 0.8 mm thick.

How many components are on the Contapassi-V1?

27 components, from 17 distinct parts. The full bill of materials is listed on this page.

Where can I download the Contapassi-V1 design files?

From the daniele-boerio/contapassi-V1 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Contapassi-V1 design in my own project?

The repository has no license, so all rights stay with daniele-boerio. Use it as a reference, and ask the author before reusing the design.