Transmitter
DrGlaucous·FightingRobot·RB1/Schematic/Transmitter/Transmitter.kicad_pcb
About the Transmitter PCB
Transmitter is an open source STM32 PCB design by DrGlaucous, published on GitHub. It is a 2-layer board measuring 70 × 30 mm, with 4 components from 4 distinct parts.
Its main chip is the BP, from the STM32 family. Other key parts include the Mini360 and RFM69HW. By type, the board carries 3 ICs and 1 connector.
It belongs with the robotics & motion designs in this gallery.
From the project
Use RFM69 to transmit PPM cheaply
This is where I put everything relating to designing a small, "antweight" combat robot.
The "Transmitter" module decodes PPM signals from the controller and sends their digital values over the radio to the vehicle. There are recievers that output PPM directly without the need for the RFM middleman, but those are expensive and radio-specific. The extra range those modules would provide would be moot in the context of miniature combat robots. The analog transmitters additionally do not provide the customization abillity the digital transmiter has.
Main components on the Transmitter
Transmitter bill of materials (BOM)
4 components, 4 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Mini360 | Mini360 | U1 |
| 1 | RFM69HW | HOPERF_RFM69HW | U2 |
| 1 | BP | blue_pill | U3 |
| 1 | Remote Umbilical | PinHeader_1x04_P2.54mm_Vertical | J2 |
Transmitter design files
The KiCad project lives in the DrGlaucous/FightingRobot repository on GitHub; these links point at the commit this page was built from.
Transmitter: common questions
What microcontroller does the Transmitter use?
The Transmitter is built around the BP, from the STM32 family.
How big is the Transmitter PCB?
The Transmitter measures 70 × 30 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Transmitter?
4 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Transmitter design files?
From the DrGlaucous/FightingRobot repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Transmitter design in my own project?
The repository has no license, so all rights stay with DrGlaucous. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the Transmitter without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.
More boards in FightingRobot
Similar boards
STM32
LumenPnP Motherboard
opulo-inc
149 × 95 mm296 parts4LCC-BY-SA-4.03.7kSTM32
Type g
google
169 × 30 mm24 parts2LApache-2.02.9kSTM32
Main panel
google
234 × 84 mm26 parts4LApache-2.02.9kSTM32
Base
google
52.3 × 52.3 mm36 parts2LApache-2.02.9kSTM32
Type a
google
150 × 30 mm14 parts2LApache-2.02.9kSTM32
Type c
google
188 × 30 mm17 parts2LApache-2.02.9k