HardLabs

Ark

Elektroniikkakerho·Led-merkki·kicad/ark/ark.kicad_pcb

Ark PCB layout, top view — open source AVR/Arduino board by Elektroniikkakerho

About the Ark PCB

Ark is an open source AVR/Arduino PCB design by Elektroniikkakerho, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 61.5 × 61.4 mm, with 40 components from 6 distinct parts.

Its main chip is the ATTINY861-S, from the AVR/Arduino family. By type, the board carries 32 diodes, 4 resistors, 2 connectors, 1 IC and 1 capacitor.

From the project

Haalarimerkki sinisellä ledisalamalla!

Levyyn on myös suunniteltu kytkin, jolla voisi vaikka sammuttaa laitteen tai toimittaa muuta toiminnallisuutta, mutta näitä ei ole koodissa toteutettu vieläkään.

Kuusipinninen liitin on ohjelmointia varten ja sitä kautta ohjelma siirretääm mikrokontrollerille. Ohjelmointi hoituu Arduinon ISP:n kautta.

Nyt kun sinulla on piirilevy, laitetaampa siihen komponentit kiinni.

Ark, from the project README
From the project README

Main components on the Ark

ATTINY861-S

Ark bill of materials (BOM)

40 components, 6 distinct parts.

QtyPartRefs
1
ATTINY861-S
IC1
1
CONN_6
P1
1
CONN_2
P3
32
LED
D1, D2, D3, D4, D5, D6, D7, D8 +24
1
CP1
C1
4
110
R1, R2, R3, R4

Ark design files

The KiCad project lives in the Elektroniikkakerho/Led-merkki repository on GitHub; these links point at the commit this page was built from.

Ark: common questions

What microcontroller does the Ark use?

The Ark is built around the ATTINY861-S, from the AVR/Arduino family.

How big is the Ark PCB?

The Ark measures 61.5 × 61.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ark?

40 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Ark design files?

From the Elektroniikkakerho/Led-merkki repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Ark design in my own project?

Yes, under the terms of its GPL-3.0 license, which Elektroniikkakerho chose for the repository.

Can I test firmware for the Ark without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Led-merkki

Similar boards