HardLabs

Kone

Elektroniikkakerho·Led-merkki·kicad/kone/kone.kicad_pcb

Kone PCB layout, top view — open source AVR/Arduino board by Elektroniikkakerho

About the Kone PCB

Kone is an open source AVR/Arduino PCB design by Elektroniikkakerho, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 49.7 × 57.8 mm, with 41 components from 7 distinct parts.

Its main chip is the ATTINY861-S, from the AVR/Arduino family. By type, the board carries 31 diodes, 4 resistors, 3 connectors, 1 IC, 1 fuse and 1 capacitor.

From the project

Haalarimerkki sinisellä ledisalamalla!

Levyyn on myös suunniteltu kytkin, jolla voisi vaikka sammuttaa laitteen tai toimittaa muuta toiminnallisuutta, mutta näitä ei ole koodissa toteutettu vieläkään.

Kuusipinninen liitin on ohjelmointia varten ja sitä kautta ohjelma siirretääm mikrokontrollerille. Ohjelmointi hoituu Arduinon ISP:n kautta.

Nyt kun sinulla on piirilevy, laitetaampa siihen komponentit kiinni.

Kone, from the project README
From the project README

Main components on the Kone

ATTINY861-S

Kone bill of materials (BOM)

41 components, 7 distinct parts.

QtyPartRefs
1
ATTINY861-S
IC1
1
CONN_6
P1
2
CONN_2
P2, P3
1
Polyfuse
F1
31
LED
D1, D2, D3, D4, D5, D6, D7, D8 +23
1
CP1
C1
4
110
R1, R2, R3, R4

Kone design files

The KiCad project lives in the Elektroniikkakerho/Led-merkki repository on GitHub; these links point at the commit this page was built from.

Kone: common questions

What microcontroller does the Kone use?

The Kone is built around the ATTINY861-S, from the AVR/Arduino family.

How big is the Kone PCB?

The Kone measures 49.7 × 57.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Kone?

41 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Kone design files?

From the Elektroniikkakerho/Led-merkki repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Kone design in my own project?

Yes, under the terms of its GPL-3.0 license, which Elektroniikkakerho chose for the repository.

Can I test firmware for the Kone without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Led-merkki

Similar boards