Keypad
gavhu10·keypad
About the Keypad PCB
Keypad is an open source ESP32 PCB design by gavhu10, published on GitHub. It is a 2-layer board measuring 67 × 111.8 mm, with 10 components from 2 distinct parts.
Its main chip is the ESP32-S3-DevKitC-1, from the ESP32 family. By type, the board carries 9 switches and 1 IC.
It belongs with the keyboards designs in this gallery.
From the project
A simple esp32 macropad
This is my first pcb project. It uses an esp32-s3 and was made in KiCad.

Main components on the Keypad
Keypad bill of materials (BOM)
10 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-S3-DevKitC-1 | ESP32-S3-DevKitC-1-ish | U1 |
| 9 | SW_Push | SW_PUSH-12mm | SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +1 |
Keypad design files
The KiCad project lives in the gavhu10/keypad repository on GitHub; these links point at the commit this page was built from.
- Layoutkeypad.kicad_pcb
- Schematickeypad.kicad_sch
Keypad: common questions
What microcontroller does the Keypad use?
The Keypad is built around the ESP32-S3-DevKitC-1, from the ESP32 family.
How big is the Keypad PCB?
The Keypad measures 67 × 111.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Keypad?
10 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the Keypad design files?
From the gavhu10/keypad repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Keypad design in my own project?
The repository has no license, so all rights stay with gavhu10. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the Keypad without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k