Video-Amplifier

gheadcn·Video-Amplifier

Video-Amplifier PCB layout, top view — open source board by gheadcn

About the Video-Amplifier PCB

Video-Amplifier is an open source PCB design by gheadcn, published on GitHub under the MIT license. It is a 2-layer board measuring 55.9 × 38.1 mm, with 24 components from 9 distinct parts.

Other key parts include the THS7374IPWR. By type, the board carries 12 resistors, 8 capacitors, 3 connectors and 1 IC.

It belongs with the audio and power & battery designs in this gallery.

From the project

A simple video amplifier designed for use in a SuperGun

A simple video amplifier designed for use in a SuperGun. The board is a light wrapper around the TI THS7374 Video Amplifier. It takes in an RBSs signal from a JAMMA board (0–3V AC swing, 0–5V DC bias, high input impedance: 1–10kΩ) and converts it to consumer set friendly outputs (RGB inputs: 0.7V AC, 0–2V DC bias, at 75 ohms impedance).

The basic idea behind the board is to be configurable to how you want it. The input and outputs are designed as terminal blocks that can take any 20 - 26 AWG wire which makes it easy to connect to just about anything on both sides. In cases where you might be…

Video-Amplifier, from the project README
From the project README

Main components on the Video-Amplifier

Video-Amplifier bill of materials (BOM)

24 components, 9 distinct parts.

QtyPartRefs
1
THS7374IPWR
IC1
1
Signal In
J1
1
Power In
J2
1
Signal Out
J3
4
0.1uf
C1, C2, C3, C4
4
330uf
C5, C6, C7, C8
4
1k
R1, R2, R3, R4
4
390
R5, R6, R7, R8
4
75
R9, R10, R11, R12

Video-Amplifier design files

The KiCad project lives in the gheadcn/Video-Amplifier repository on GitHub; these links point at the commit this page was built from.

Video-Amplifier: common questions

How big is the Video-Amplifier PCB?

The Video-Amplifier measures 55.9 × 38.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Video-Amplifier?

24 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Video-Amplifier design files?

From the gheadcn/Video-Amplifier repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Video-Amplifier design in my own project?

Yes, under the terms of its MIT license, which gheadcn chose for the repository.

Similar boards