Cartalk esp32

gibsonbailey·cartalk_esp32_pcb

Cartalk esp32 PCB layout, top view — open source ESP32 board by gibsonbailey

About the Cartalk esp32 PCB

Cartalk esp32 is an open source ESP32 PCB design by gibsonbailey, published on GitHub. It is a 2-layer board measuring 22.9 × 48.8 mm, with 22 components from 17 distinct parts.

Its main chip is the ESP32_WROOM32_SKINNY, from the ESP32 family. Other key parts include the CP2104, HUB75 Connector Female and AP2112-3.3. By type, the board carries 6 capacitors, 4 resistors, 3 ICs, 2 transistors, 2 test points and 2 diodes.

Main components on the Cartalk esp32

CP2104HUB75 Connector FemaleAP2112-3.3

Cartalk esp32 bill of materials (BOM)

22 components, 17 distinct parts.

QtyPartRefs
1
CP2104
IC1
1
HUB75 Connector Female
U1
1
AP2112-3.3
U2
2
mmbt2222
Q1, Q2
1
ESP32_WROOM32_SKINNY
X2
1
10118192-0002LF
J1
1
KMR2
SW2
2
TestPoint
TP1, TP2
1
RED
D3
1
MBR120
D4
2
10uF
C1, C2
2
1uF
C4, C7
1
10µF
C6
1
10µF
C8
2
100K
R7, R12
1
1K
R10
1
10K
R13

Cartalk esp32 design files

The KiCad project lives in the gibsonbailey/cartalk_esp32_pcb repository on GitHub; these links point at the commit this page was built from.

Cartalk esp32: common questions

What microcontroller does the Cartalk esp32 use?

The Cartalk esp32 is built around the ESP32_WROOM32_SKINNY, from the ESP32 family.

How big is the Cartalk esp32 PCB?

The Cartalk esp32 measures 22.9 × 48.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Cartalk esp32?

22 components, from 17 distinct parts. The full bill of materials is listed on this page.

Where can I download the Cartalk esp32 design files?

From the gibsonbailey/cartalk_esp32_pcb repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Cartalk esp32 design in my own project?

The repository has no license, so all rights stay with gibsonbailey. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Cartalk esp32 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards